Hello, I have an EVO-ALL connected to a RS-X60-EDP+ Remote Start.
The remote start runs properly when a chipped key is in the PATS halo.
I attempted to program the EVO-ALL following programming sequence #2.
I have both keys and the bypass appears to be reading the input.
When I complete the programming sequence, by starting the remote start routine, the engine cranks, but will not run.
Subsequent attempts generate no crank at all unless I follow the programming steps again, however, it will only crank for the first remote start cycle.
The remote start only works if the chipped key is in the halo of the PATS (key need not be inserted).
The following wires are connected on the EVO-ALL
Blue GWR to remote start
Yellow Ignition to remote start
TX to PATS
RX to PATS
4 Pin bus to the remote start